Jackson Dishwasher AJ-44 User Manual download pdf (Page 6)

tor weldment. Once removed, set to the side along with its gasket.

22. Separate the rinse plumbing from the rest of the incoming

plumbing by loosening the union. Ensure that the gasket on the

bottom of the rinse injector stays with the assembly as you remove

it.

23. Remove the remaining half of the union from the incoming

plumbing.

24. Remove the incoming water pressure regulator from the incom-

ing plumbing and replace with the union half that was removed in

step 23. Place the water pressure regulator on the end that the

union half was removed from.

25. Place the removed rinse plumbing assembly (with the gasket)

in the hole left open from when you removed the hole cover weld-

ment in step 21. Tighten the two halves of the union together.

26. Place the hole cover weldment (with its gasket) over the hole

from where the rinse plumbing assembly was originally installed.

Tighten down with the locknuts.

27. Re-install the rinse manifold (with its gasket) by connecting it to

the rinse injector weldment at its new location. Remove the locknut

from the stud for the bracket down near the rack rails and then

secure the bracket to the machine using the same lock nut.

28. Re-install the lower wash arm support bracket to the pawl bar

support on the end of the tub opposite from where it was removed.

29. Re-install the upper and lower rinse arms. Reinstall the lower

rinse arm support bracket.

30. Re-install the lower wash arm assembly, turning it 180B

and

locking it in place with the locking screw.

31. Re-install the pawl bar. Ensure that the pawl bar is placed so

that when racks are placed in the unit, the pawl bar dogs fold down.

32. Re-install the upper wash arm assembly. If you performed all of

the actions outlined in step 2, when you install it, it will be directly

over the lower wash arm assembly.

33. Remove the heater box cover by unscrewing the four screws

holding it on.

www.jacksonmsc.com

AJ-44 Conveyor Direction Change Instructions

Revision A (03/30/2005)

Removing the hole cover weldment

Loosening the union on the incoming plumbing

Removing the heater box cover

Front of rack conveyor showing the conveyor

switches

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

Jackson Dishwasher AJ-44 User Manual Page 6

Comments to this Manuals

Related products and manuals for Unknown Jackson Dishwasher AJ-44