Jackson Dishwasher AJ-44 User Manual download pdf (Page 5)

16. On the drain plumbing, the rinse drain tube needs to be

removed from the plumbing, as well as the wash drain tube. Both

of these tubes are secured with hose clamps. Loosen the hose

clamps and pull the tubes off.

17. The tee that the rinse drain nipple is in must be turned 180B

that it is facing the opposite direction. This may require dismantling

the plumbing by removing the tee with the wash drain barb in it. Put

the plumbing back together, after ensuring that the rinse drain tee

has been rotated. Use thread tape to protect the threads while put

ting the plumbing back together. Ensure that the wash drain barb

is in the exatc same position it was prior to this step.

18. On the underside of the tub, remove the rinse drain weldment

and the rinse drain plug. Switch their locations so that the rinse

drain weldment is in the spot that the rinse drain plug was in.

19. Reconnect the rinse drain hose and the wash drain hose to the

drain plumbing.

20. On the opposite end from where they were removed, install the

front and rear rinse pan assembly locating brackets.

Note: the

brackets are mounted to the bolts that secure the tub weld

ment to the frame.

Install the brackets one at a time and ensure

that they are firmly tightened down once installed.

21. Remove the hole cover weldment from the top of the hood. The

cover is located on the end of the hood opposite of the rinse injec

www.jacksonmsc.com

AJ-44 Conveyor Direction Change Instructions

Revision A (03/30/2005)

Lifting out the rinse tray assembly

Removing a rinse tray guide bracket

Loosening the rinse drain hose from the rinse

drain nipple

Removing the rinse drain weldment

Removing the rinse drain plug

1 2 3 4 5 6 7 8

No comments

Jackson Dishwasher AJ-44 User Manual Page 5