Jackson Door-type Dishmachine TEMPSTAR GPX User Manual download pdf (Page 28)

Tempstar/HH GPX Series Technical Manual 7610-002-57-32

Issued: 07-24-2006 Revised: N/A

SECTION 5: SERVICE PROCEDURES

19. Using the small flathead screwdriver, lift out the screen

retainer. Verify that the holes in it are free of clogs and debris.

20. Again using the small flathead screwdriver, carefully

remove the mesh screen from inside the valve body. The

screen should be taken and rinsed out to remove any debris

fouling it.

21. With the mesh screen removed, look down into the valve

and verify it is not clogged. Remove any foreign objects from

the valve body that would obstruct flow.

22. Reassemble the valve, reversing the steps needed to take

it apart. Replace defective replacement parts with new parts

from ordered kits. Ensure that components are sufficiently

tightened to prevent leakage.

AFTER MAINTENANCE ACTIONS

Reconnect the incoming water (if disconnected) and

turn on. Then restore power to the unit. Run the unit for at

least 10 minutes to ensure there are no leaks. If any problems

arise please contact your Jackson representative.

SPECIAL PARTS

Plunger and Spring Replacement Kit

06401-003-07-40

Diaphragm and O-Ring Replacement Kit (3/4”)

06401-003-07-42

110V Coil and Housing

06401-003-07-43

RINSE SOLENOID VALVE REPAIR PARTS KIT (CONTINUED)

Removing the screen retainer

Removing the mesh strainer screen

View inside the solenoid valve body

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 62 63

No comments

Jackson Door-type Dishmachine TEMPSTAR GPX User Manual Page 28