Jackson Door-type Dishmachine TEMPSTAR GPX User Manual download pdf (Page 14)

Tempstar/HH GPX Series Technical Manual 7610-002-57-32

Issued: 07-24-2006 Revised: N/A

SECTION 2: INSTALLATION/OPERATION INSTRUCTIONS

INSTALLATION INSTRUCTIONS

GAS BOOSTER HEATER ELECTRICAL INSTALLATION: The gas booster heater must have a separate electric hookup than

that supplied to the dishmachine. Please refer to the manual supplied with your gas booster heater.

GAS CONNECTION TO THE BOOSTER HEATER: Please refer to the manual supplied with your gas booster heater.

VENTILATION OF THE GAS BOOSTER HEATER: Please refer to the manual supplied with your gas booster heater.

PLUMBING CHECK: Slowly turn on the water supply to the machine after the incoming fill line and the drain line have been

installed. Check for any leaks and repair as required. All leaks must be repaired prior to placing the machine in operation.

ELECTRICAL POWER CONNECTION: Electrical and grounding connections must comply with the applicable portions of the

National Electrical Code ANSI/NFPA 70 (latest edition) and/or other electrical codes.

Disconnect electrical power supply and place a tag at the disconnect switch to indicate that you are working on the circuit.

The dishmachine data plate is located on the right side and to the front of the machine. Refer to the data plate for machine

operating requirements, machine voltage, total amperage load and serial number.

To install the incoming power lines, remove the control box cover. Install 3/4” conduit into the pre-punched holes in the back of

the control box. Route power wires and connect to power block and grounding lug. Install the service wires (L1 and L2) to the

appropriate terminals as they are marked on the terminal block. Install the grounding wire into the lug provided. and tighten the

connections. It is recommended that “DE-OX” or another similar anti-oxidation agent be used on all power connections.

VOLTAGE CHECK: Ensure that the power switch is in the OFF position and apply power to the dishmachine. Check the incom-

ing power at the terminal block and ensure it corresponds to the voltage listed on the data plate. If not, contact a qualified serv-

ice agency to examine the problem. Do not run the dishmachine if the voltage is too high or too low. Shut off the service break-

er and mark it as being for the dishmachine. Advise all proper personnel of any problems and of the location of the service

breaker. Replace the control box cover and tighten down the screws.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 62 63

No comments

Jackson Door-type Dishmachine TEMPSTAR GPX User Manual Page 14