Jackson Avenger Undercounter Dishmachine Series Avenger LT User Manual download pdf (Page 14)

SHOCK ABSORBER: It is also recommended that a shock absorber (not supplied) be installed in the incoming water line. This

prevents line hammer (hydraulic shock), induced by the solenoid valve as it operates, from causing damage to the equipment.

CONNECTING THE DRAIN LINE: The dishmachine has a pumped (pressure) drain capable of pumping waste water to a

height of 24 inches from the floor to the kitchen’s drain system. Each dishmachine is supplied with a 10 foot long hose. This

ships inside the unit. When installed, it will extend from the rear side of the machine. There must also be an air gap between

the machine drain line and the floor sink or drain. If a grease trap is required by code, it should have a flow capacity of 12 gal-

lons per minute.

PLUMBING CHECK: Slowly turn on the water supply to the machine after the incoming fill line and the drain line have been

installed. Check for any leaks and repair as required. All leaks must be repaired prior to placing the machine in operation.

ELECTRICAL POWER CONNECTION: Electrical and grounding connections must comply with the applicable

portions of the National Electrical Code ANSI/NFPA 70 (latest edition) and/or

other electrical codes.

Disconnect electrical power supply and place a tag at the disconnect switch to

indicate that you are working on the circuit.

The data plate is located toward the right front side of the dishmachine. Refer

to the data plate for machine operating requirements, machine voltage, total

amperage load and serial number.

To install the incoming power lines, remove the back panel. This will require

taking a phillips head screwdriver and removing the two screws at the bottom

of the back panel; remove the back panel and set out of the way. Install 3/4”

conduit into the pre-punched holes in the back of the control box. Route power

wires and connect to power block and grounding lug. Install the service wires

(L1 and L2) to the appropriate terminals as they are marked on the terminal

block. Install the grounding wire into the lug provided. It is recommended that

“DE-OX” or another similar anti-oxidation agent be used on all power connec-

tions.

VOLTAGE CHECK: Ensure that the power switch is in the OFF position and apply power to the dishmachine. Check the incom-

ing power at the terminal block and ensure it corresponds to the voltage listed on the data plate. If not, contact a qualified ser-

vice agency to examine the problem. Do not run the dishmachine if the voltage is too high or too low. Shut off the service break-

er and mark it as being for the dishmachine. Advise all proper personnel of any problems and of the location of the service

breaker. Replace the control box cover and tighten down the screws.

Avenger™ Series Technical Manual 7610-003-34-01 Rev. A

Issued: 05-02-2007 Revised: N/A

SECTION 2: INSTALLATION/OPERATION INSTRUCTIONS

ELECTRICAL INSTALLATION INSTRUCTIONS

Back of unit showing Terminal Block Box

Electrical Connection

Ground Lug

Terminal Block

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 60 61

No comments

Jackson Avenger Undercounter Dishmachine Series Avenger LT User Manual Page 14